Lexus ES: Installation
INSTALLATION
PROCEDURE
1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
HINT:
Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Click here .gif)
(a) Apply a light coat of engine coolant to the O-ring of the engine coolant temperature sensor.
(b) Install the engine coolant temperature sensor to the water outlet with a new clip.
NOTICE:
- If the engine coolant temperature sensor has been struck or dropped, replace it.
- If reusing the engine coolant temperature sensor, be sure to inspect the O-ring.
- Make sure that the O-ring is not cracked or moved out of place when installing the engine coolant temperature sensor.
(c) Connect the engine coolant temperature sensor connector.
2. INSTALL INVERTER WITH CONVERTER ASSEMBLY
Click here
3. INSTALL NO. 2 ENGINE COOLANT TEMPERATURE SENSOR
(a) Apply a light coat of engine coolant to the O-ring of the No. 2 engine coolant temperature sensor.
(b) Install the No. 2 engine coolant temperature sensor to the radiator pipe with a new clip.
NOTICE:
- If the No. 2 engine coolant temperature sensor has been struck or dropped, replace it.
- If reusing the No. 2 engine coolant temperature sensor, be sure to inspect the O-ring.
- Make sure that the O-ring is not cracked or moved out of place when installing the No. 2 engine coolant temperature sensor.
(c) Connect the No. 2 engine coolant temperature sensor connector.
4. INSTALL INLET AIR CLEANER ASSEMBLY
Click here
5. INSTALL COOL AIR INTAKE DUCT SEAL
Click here
6. ADD ENGINE COOLANT (for Engine)
Click here
7. INSPECT FOR COOLANT LEAK (for Engine)
Click here
8. PERFORM INITIALIZATION
(a) Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 IGNITION COIL ASSEMBLY *2 NO. 1 ENGINE COVER SUB-ASSEMBLY *3 SPARK PLUG - - N*m (kgf*cm, ft.*lbf): Specified torque - -
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ign
SEE MORE:
Coolant
ComponentsCOMPONENTS ILLUSTRATION *1 RADIATOR CAP SUB-ASSEMBLY *2 RADIATOR DRAIN COCK PLUG *3 NO. 1 ENGINE UNDER COVER - - ReplacementREPLACEMENT CAUTION / NOTICE / HINT CAUTION: Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and rad
Front Right Sensor Malfunction (C1AE4)
DESCRIPTION The front corner ultrasonic sensor RH is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front corner ultrasonic sensor RH. If the front corner ultrasonic sensor RH has an open circuit or other malfunction, it will no
