Lexus ES: Installation
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / 2gr-fks (fuel) / Fuel Pump Ecu / Installation
INSTALLATION
PROCEDURE
1. INSTALL FUEL PUMP CONTROL ECU BRACKET
(a) Install the fuel pump control ECU bracket to the fuel pump control ECU with the 2 bolts.
Torque:
4.5 N·m {46 kgf·cm, 40 in·lbf}
2. INSTALL FUEL PUMP CONTROL ECU
(a) Install the fuel pump control ECU to the vehicle body with the nut.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
(b) Connect the 2 fuel pump control ECU connectors.
(c) Return the room partition panel insulator to its original position.
(d) w/ Silencer Sheet:
(1) Install the No. 2 room partition panel silencer sheet to the room partition panel insulator.
3. INSTALL REAR SEAT SIDE GARNISH LH
Click here .gif)
4. INSTALL REAR DOOR SCUFF PLATE LH
Click here
5. INSTALL REAR SEAT ASSEMBLY
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FUEL SUCTION PLATE SUB-ASSEMBLY *2 FUEL SENDER GAUGE ASSEMBLY *3 FUEL SUB-TANK - -
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel
SEE MORE:
Open in One Side of Bus 3 Branch Line
DESCRIPTION When the CAN bus main lines are normal (no open, short to ground, short to +B or short between lines) and there is an ECU or sensor on the "Communication Bus Check" screen that is indicated as not communicating or whose connection status on the "Communication Bus Check" screen changes in
Sensor (Motor) Failure (B2341,B2344)
DESCRIPTION When the sliding roof ECU (sliding roof drive gear sub-assembly) detects a motor malfunction and the sliding roof operation is stopped, DTC B2341 is stored. When the sliding roof ECU (sliding roof drive gear sub-assembly) detects a gear position malfunction and the sliding roof operation
© 2016-2026 Copyright www.lexguide.net
