Lexus ES manuals

Lexus ES: Installation

Lexus ES (XZ10) Service Manual / Drivetrain / Ub80f (automatic Transmission / Transaxle) / Combination Switch / Installation

INSTALLATION

PROCEDURE

1. INSTALL DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY)

(a) Install the drive mode select switch (combination switch assembly) to the instrument cluster finish panel assembly with the 3 screws.

(b) Engage the clamp to connect the wire harness to the instrument cluster finish panel assembly.

(c) Connect the drive mode select switch (combination switch assembly) connector.

2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Click here

READ NEXT:

 Removal

REMOVAL PROCEDURE 1. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY Click here 2. REMOVE DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY) (a) Disconnect the drive mode select switch (comb

 Differential Case

 Components

COMPONENTS ILLUSTRATION *1 FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING (INNER RACE) *2 FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING (OUTER RACE) *3 FRONT DIFFERENTIAL

SEE MORE:

 Control Module Communication Bus OFF (U0073,U0126,U0142,U0182)

DESCRIPTION These DTCs are stored if a CAN communication malfunction occurs between the headlight ECU sub-assembly RH and other ECUs. for LED Type Turn Signal Light DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from U0073 Control Module Communication Bus OFF

 Manifold Absolute Pressure / Barometric Pressure Sensor Circuit Short to Ground (P010511)

DESCRIPTION The manifold absolute pressure sensor detects the intake manifold pressure as a change in voltage. The ECM calculates the intake manifold pressure based on this voltage. The ECM calculates the EGR valve assembly and purge VSV opening amount according to changes in the intake manifold pr

© 2016-2026 Copyright www.lexguide.net