Lexus ES: Installation
Lexus ES (XZ10) Service Manual / Drivetrain / P710 (hybrid Transmission / Transaxle) / Combination Switch / Installation
INSTALLATION
PROCEDURE
1. INSTALL DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY)
(a) Install the drive mode select switch (combination switch assembly) to the instrument cluster finish panel assembly with the 3 screws.
(b) Engage the clamp to connect the wire harness to the instrument cluster finish panel assembly.
(c) Connect the drive mode select switch (combination switch assembly) connector.
2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
Click here .gif)
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY Click here 2. REMOVE DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY) (a) Disconnect the drive mode select switch (comb
Adjustment
ADJUSTMENT PROCEDURE 1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH Click here 2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH Click here 3. REMOVE NO. 1 ENGINE UNDER COVER Click here 4. RE
SEE MORE:
Open in Bus 4 Main Bus Line
DESCRIPTION There may be an open circuit in one of the CAN main bus lines when the resistance between terminals 22 (CA2H) and 7 (CA2L) of the central gateway ECU (network gateway ECU) is 70 Ω or higher. Symptom Trouble Area Resistance between terminals 22 (CA2H) and 7 (CA2L) of the central
Terminals Of Ecu
TERMINALS OF ECU CHECK LUGGAGE CLOSER MOTOR ASSEMBLY (a) Disconnect the R7 luggage closer motor assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
© 2016-2026 Copyright www.lexguide.net
