Lexus ES: How To Proceed With Troubleshooting
PROCEDURE
| 1. | CHECK TIRE AND WHEEL SYSTEM |
| DIAGNOSIS OF IRREGULAR TIRE WEAR | .gif) | GO TO STEP 11 |
|
.gif)
| 2. | TIGHTEN WHEEL NUTS |
Click here .gif)
|
| 3. | INSPECT TIRES |
Click here
| NG | | GO TO STEP 10 |
|
| 4. | INSPECT AND/OR ADJUST WHEEL BALANCE |
Click here
|
| 5. | INSPECT FRONT AXLE HUB BEARING LOOSENESS AND AXLE HUB RUNOUT |
Click here
| NG | | GO TO STEP 9 |
|
| 6. | INSPECT REAR AXLE HUB BEARING LOOSENESS AND AXLE HUB RUNOUT |
for 2WD: Click here
for AWD: Click here
| NG | | GO TO STEP 8 |
|
| 7. | PERFORM ROAD TEST |
| NEXT | | RETURN VEHICLE TO CUSTOMER |
| 8. | REPAIR REAR AXLE HUB BEARING LOOSENESS AND AXLE HUB RUNOUT |
for 2WD: Click here
for AWD: Click here
| NEXT | | GO TO STEP 7 |
| 9. | REPAIR FRONT AXLE HUB BEARING LOOSENESS AND AXLE HUB RUNOUT |
Click here
| NEXT | | GO TO STEP 6 |
| 10. | REPAIR OR REPLACE TIRE(S) |
| NEXT | | GO TO STEP 4 |
| 11. | INSPECT TIRES |
Click here
|
| 12. | REPAIR OR REPLACE TIRE(S) |
|
| 13. | INSPECT AND/OR ADJUST FRONT WHEEL ALIGNMENT |
Click here
|
| 14. | INSPECT AND/OR ADJUST REAR WHEEL ALIGNMENT |
Click here
|
| 15. | PERFORM ROAD TEST |
| NEXT | | RETURN VEHICLE TO CUSTOMER |
READ NEXT:
Inspection
INSPECTION PROCEDURE 1. INSPECT TIRES (a) Inspect the tires for wear and proper inflation pressure. Cold Tire Inflation Pressure: Tire Size Cold Tire Inflation Pressure Front Rear 215/
SEE MORE:
Washer Fluid Level Warning Switch Circuit
DESCRIPTION When the washer fluid level is lower than a certain level, a warning message is displayed on the combination meter assembly. WIRING DIAGRAM PROCEDURE 1. READ VALUE USING TECHSTREAM (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstrea
Remote Up / Down Function does not Operate
DESCRIPTION When the power switch on (IG), the multiplex network master switch assembly sends remote up and down signals to each power window regulator motor assembly via LIN communication. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
The power window control system uses the LIN communication
