Lexus ES: Front Door
READ NEXT:
COMPONENTS ILLUSTRATION *A for Driver Side *B for Front Passenger Side *C w/ Illumination - - *1 BOX BOTTOM MAT *2 COURTESY LIGHT ASSEMBLY *3 DOOR ARMREST COVER *
DISASSEMBLY CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during
ADJUSTMENT CAUTION / NOTICE / HINT *a Centering Bolt *b Standard Bolt HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
Center
SEE MORE:
DESCRIPTION The headlight ECU sub-assembly LH stores this DTC if the value from the rear height control sensor sub-assembly LH is out of range when performing initialization of the headlight ECU sub-assembly LH, such as when the vehicle is not level or jacked up. DTC No. Detection Item DTC De
Removal
REMOVAL
PROCEDURE
1. REMOVE WHEEL ASSEMBLY
(a) Loosen the axle hub nuts approximately 90°.
(b) Lift up the vehicle and remove the axle hub nuts and wheel assembly.
Installation
INSTALLATION
PROCEDURE
1. INSTALL WHEEL ASSEMBLY
NOTICE:
Only use axle hub nuts that are co
© 2016-2024 Copyright www.lexguide.net