Lexus ES: Flow Shutting Valve (for Atf)
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / A25a-fks (cooling) / Flow Shutting Valve (for Atf)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FRONT FENDER APRON SEAL LH *2 FRONT WHEEL OPENING EXTENSION PAD LH *3 FRONT WHEEL OPENING EXTENSION PAD RH *4 NO. 1 ENGINE UNDER COVER *5 NO. 2 ENG
Inspection
INSPECTION PROCEDURE 1. INSPECT FLOW SHUTTING VALVE (NO. 1 WATER BY-PASS HOSE) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Con
Installation
INSTALLATION PROCEDURE 1. INSTALL FLOW SHUTTING VALVE (NO. 1 WATER BY-PASS HOSE) (a) Install the flow shutting valve (No. 1 water by-pass hose) with the bolt. Torque: 19 N·m {194 kgf·cm, 14 ft·lbf
SEE MORE:
Adjustment
ADJUSTMENT PROCEDURE 1. PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION HINT: The blind spot monitor beam axis confirmation is performed to confirm whether the sensor's beam axis is correct, and perform adjustment of the beam axis by using reflector. (a) When performing the blind spot monitor beam
Control Module Communication Bus OFF (U0073,U0126,U0142,U0182)
DESCRIPTION These DTCs are stored if a CAN communication malfunction occurs between the headlight ECU sub-assembly RH and other ECUs. for LED Type Turn Signal Light DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from U0073 Control Module Communication Bus OFF
© 2016-2026 Copyright www.lexguide.net
