Lexus ES: Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Lane Control / Trouble Codes.
Chassis > Lane Control > Trouble Codes(e) Check for DTCs (Test Failed / Pending / Confirmed).
| Techstream Display | Description |
|---|---|
| Test Failed | Represent malfunctions that were detected during the current trip. |
| Pending | Represent malfunctions which have occurred since the DTCs were last cleared but have not been confirmed. |
| Confirmed | Represent malfunctions which have occurred since the DTCs were last cleared and have been confirmed. (The number of trips since the DTC was stored may differ for each DTC.) |
HINT:
Freeze frame data is stored respectively for pending DTCs, confirmed DTCs and the latest DTCs.
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Lane Control / Clear DTCs.
Chassis > Lane Control > Clear DTCs(e) Clear the DTCs.
HINT:
Clearing the DTCs will also clear the freeze frame data.
READ NEXT:
Freeze Frame Data
FREEZE FRAME DATA DESCRIPTION (a) Whenever a lane control system DTC is stored, the forward recognition camera stores the current vehicle state as Freeze Frame Data. CHECK FREEZE FRAME DATA (a) Connec
Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) When a malfunction occurs in the lane control system, a message will be displayed on the multi-information display and, depending on the malfunction, functions o
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY *A w/o Seat Heater *B w/ Seat Heater (a) Disconnect the G39 air conditioning amplifier assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Panoramic Moon Roof System DTC No. Detection Item Link B2341 Sensor (Motor) Failure B2342 Switch Failure B2343 Position Initialization Incomplete B2344 Position Failure B2345 Motor Control Relay Stuck ON
