Lexus ES manuals

Lexus ES: Dtc Check / Clear

DTC CHECK / CLEAR

CHECK FOR DTC (CHECK USING TECHSTREAM)

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Active Noise Control / Trouble Codes.

Body Electrical > Active Noise Control > Trouble Codes

(e) Check the details of the DTC(s).

Click here

CLEAR DTC (CLEAR USING TECHSTREAM)

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Active Noise Control / Trouble Codes.

(e) Clear DTCs.

Body Electrical > Active Noise Control > Clear DTCs

READ NEXT:

 Freeze Frame Data

FREEZE FRAME DATA CHECK FREEZE FRAME DATA HINT: Whenever an active noise control system DTC is stored, the stereo component equalizer assembly stores the current vehicle state as freeze frame data. (a

 How To Proceed With Troubleshooting

PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT 2. CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK NEXT 3. INSPECT AUXILIARY BATTERY VOLTAGE (a)

 Input / Output Signal Circuit

DESCRIPTION The stereo component equalizer assembly uses this circuit to send and receive signals to and from the stereo component amplifier assembly. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS

SEE MORE:

 Fail-safe Chart

FAIL-SAFE CHART FAIL-SAFE CHART (a) When the skid control ECU (brake actuator assembly) detects a solenoid valve malfunction or abnormal signal from a sensor, the brake actuator assembly cuts power and sends a signal indicating a malfunction of the electronically controlled brake system to the ECM.

 Terminals Of Ecu

TERMINALS OF ECU CHECK SWING GRILLE ACTUATOR ASSEMBLY (a) Disconnect the z23 swing grille actuator assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconnected. Tester Co

© 2016-2026 Copyright www.lexguide.net