Lexus ES: Freeze Frame Data
FREEZE FRAME DATA
CHECK FREEZE FRAME DATA
HINT:
Whenever an active noise control system DTC is stored, the stereo component equalizer assembly stores the current vehicle state as freeze frame data.
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Active Noise Control / Trouble Codes.
Body Electrical > Active Noise Control > Trouble Codes(e) According to the Techstream display, select a DTC that stored freeze frame data.
NOTICE:
Read the freeze frame data recorded when the DTC was stored.
LIST OF FREEZE FRAME DATA
Body Electrical > Active Noise Control| Tester Display | Measurement Item | Range | Reference Value | Diagnostic Note |
|---|---|---|---|---|
| Total Distance Traveled | Displays the current total driving distance | 0 to 16777215 | Equivalent to the actual total driving distance | Refer to the Total Distance Traveled - Unit for the units |
| Total Distance Traveled - Unit | Displays the current total driving distance units | km or mile | Units according destination | - |
READ NEXT:
How To Proceed With Troubleshooting
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT 2. CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
NEXT 3. INSPECT AUXILIARY BATTERY VOLTAGE (a)
Input / Output Signal Circuit
DESCRIPTION The stereo component equalizer assembly uses this circuit to send and receive signals to and from the stereo component amplifier assembly. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS
Crankshaft Position Sensor "A" No Signal (P033531)
DESCRIPTION This DTC is output when a malfunction has occurred in the engine pulse signal system from the ECM. DTC No. Detection Item DTC Detection Condition Trouble Area P033531 Cranks
SEE MORE:
Open Circuit in Main Relay 1 (C1311,C1312)
DESCRIPTION The main relay supplies power to the switching solenoid and the linear solenoid. The main relay remains on for approximately 2 minutes after the power switch is turned off and the input of brake pedal operation signals stops, and supplies power to the system to keep it ready to operate.
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR SPOILER SUB-ASSEMBLY HINT: When installing a new rear spoiler sub-assembly, heat the luggage compartment door panel and rear spoiler sub-assembly using a heat light. Heating Temperature Item Temperature Luggage Compartment Door Panel 40 to 60°C (104
