Lexus ES: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Safety Connect System| DTC No. | Detection Item | Link |
|---|---|---|
| B153711 | Telephone Sub Antenna Circuit Short to Ground | |
| B153713 | Telephone Sub Antenna Circuit Open | |
| B157011 | Indicator (Red) Circuit Short to Ground | |
| B157013 | Indicator (Red) Circuit Open | |
| B157111 | Indicator (Green) Circuit Short to Ground | |
| B157113 | Indicator (Green) Circuit Open | |
| B157213 | Microphone Circuit Open | |
| B15A804 | DCM System Internal Failure | |
| B15C111 | GNSS Antenna Circuit Short to Ground | |
| B15C113 | GNSS Antenna Circuit Open | |
| B15C464 | Airbag Signal Signal Plausibility Failure | |
| B15C511 | Emergency Call Switch Circuit Short to Ground | |
| B15C513 | Emergency Call Switch Circuit Open | |
| B15CB11 | Telephone Main Antenna Circuit Short to Ground | |
| B15CB13 | Telephone Main Antenna Circuit Open | |
| B15CC49 | Backup Battery Internal Electronic Failure | |
.gif)
READ NEXT:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Telematics / Troubl
Emergency Call Switch Illumination Circuit
WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be need
Green Indicator Remains Off
DESCRIPTION After engine switch on (IG), the DCM (telematics transceiver) will enter into self check mode. The manual (SOS) switch red indicator will illuminate for 2 seconds and turn off followed by
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE NO. 2 DOOR TRIM PAD Click here 2. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during luggage door opening cancel switch assembly removal/installation are shown below. Necessary Procedure A
