Lexus ES: Diagnostic Trouble Code Chart
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Window / Glass / Power Window Control System (for Gasoline Model) / Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Power Window Control System (for Gasoline Model)| DTC No. | Detection Item | Link |
|---|---|---|
| B2311 | Power Window Motor Malfunction | |
| B2311 | Power Window Motor Malfunction | |
| B2311 | Power Window Motor Malfunction | |
| B2311 | Power Window Motor Malfunction | |
| B2312 | Power Window Switch Malfunction | |
| B2312 | Power Window Switch Malfunction | |
| B2312 | Power Window Switch Malfunction | |
| B2312 | Power Window Switch Malfunction | |
| B2312 | Power Window Switch Malfunction | |
| B2313 | Glass Position Initialization Incomplete | |
| B2313 | Glass Position Initialization Incomplete | |
| B2313 | Glass Position Initialization Incomplete | |
| B2313 | Glass Position Initialization Incomplete | |
.gif)
READ NEXT:
Power Window Motor Malfunction (B2311)
DESCRIPTION The power window regulator motor assemblies are operated by the multiplex network master switch assembly, power window regulator switch assembly or rear power window regulator switch assem
Power Window Switch Malfunction (B2312)
DESCRIPTION The power window regulator motor assemblies are operated by the multiplex network master switch assembly, power window regulator switch assembly or rear power window regulator switch assem
Glass Position Initialization Incomplete (B2313)
DESCRIPTION The power window regulator motor assemblies are operated by the multiplex network master switch assembly, power window regulator switch assembly or rear power window regulator switch assem
SEE MORE:
DC/DC Converter Stuck On (P0A949E,P0D3319)
DTC SUMMARY MALFUNCTION DESCRIPTION This DTC indicates that a large current flowed in the boost converter. The cause of this malfunction may be one of the following: Area Main Malfunction Description Hybrid vehicle transaxle assembly
Open or short circuit in the motor or generator coil
Inspection
INSPECTION PROCEDURE 1. INSPECT FLOW SHUTTING VALVE (NO. 1 WATER BY-PASS HOSE) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 - 2 20°C (68°F) 22 to 28 Ω If the result is not as spec
© 2016-2026 Copyright www.lexguide.net
