Lexus ES manuals

Lexus ES: Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART

Parking Assist Monitor System

DTC No.

Detection Item

Link

C1611

ECU Malfunction

C1621

Back Camera Power Supply Failure

C1622

Back Camera Disconnected

C1625

Open or Short in Steering Angle Sensor +B

C1626

Steering Angle Sensor Failure

C168D

Vehicle Information Unmatched

C1691

Back Camera Initialization Incomplete

C1694

Steering Angle Initialization Incomplete

U0100

Lost Communication with ECM / PCM "A"

U0126

Lost Communication with Steering Angle Sensor Module

U0140

Lost Communication with Body Control Module

U0163

Lost Communication with Navigation Control Module

U0233

Lost Communication with Blind Spot Monitor Master Module

U1000

CAN Communication Failure (Message Registry)

U1110

Lost Communication with Intuitive Parking Assist Module

READ NEXT:

 Dtc Check / Clear

DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Chassis / Rear Camera / Trouble Codes

 How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the parking assist monitor system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT

 Image from Camera for Parking Assist Monitor is Abnormal

DESCRIPTION The video signal from the rear television camera assembly is transmitted to the multi-display assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: If the cable was disconnected fro

SEE MORE:

 Brake Pressure Control Solenoid "A" Control Circuit Short to Battery (C13C012,...,C13C049)

DESCRIPTION The ABS solenoid relay and master cylinder cut solenoid valves are built into the brake actuator assembly. Depending on the operating conditions, the master cylinder cut solenoid valves regulate the brake fluid pressure generated by the pump motor. When this DTC is stored, the fail-safe

 Operation Check

OPERATION CHECK CHECK WINDOW DEFOGGER SYSTEM (a) Turn the power switch on (IG). (b) Check that the rear window defogger wire becomes warm by operating the rear window defogger switch of the air conditioning control assembly. (c) When the vehicle is stopped, confirm that the window defogger system op

© 2016-2026 Copyright www.lexguide.net