Lexus ES: Components
Lexus ES (XZ10) Service Manual / Brake / Brake Control / Dynamic Control Systems / Vsc Off Switch / Components
COMPONENTS
ILLUSTRATION
| *1 | INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY | *2 | VSC OFF SWITCH |
READ NEXT:
Inspection
INSPECTION PROCEDURE 1. INSPECT VSC OFF SWITCH (a) Make sure that there is no looseness at the locking part and the connecting part of the connector. OK: The connector is securely connected.
Installation
INSTALLATION PROCEDURE 1. INSTALL VSC OFF SWITCH (a) Install the VSC OFF switch to the instrument cluster finish panel assembly with the 3 screws. (b) Engage the 2 clamps to install the wire harness.
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during VSC
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL PARKING BRAKE ACTUATOR ASSEMBLY (a) Apply a light coat of lithium soap base glycol grease to a new O-ring. (b) Install the O-ring to
Window Defogger Wire
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. CHECK REAR WINDOW DEFOGGER OPERATION (a) When the engine switch (for Gasoline Model) or power switch (for HV Model) is on (IG) and the rear window defogger switch is pressed, check that the window defogger system operates. 2. INSPECT REAR WIND
© 2016-2026 Copyright www.lexguide.net
