Lexus ES: Installation
Lexus ES (XZ10) Service Manual / Brake / Brake Control / Dynamic Control Systems / Vsc Off Switch / Installation
INSTALLATION
PROCEDURE
1. INSTALL VSC OFF SWITCH
(a) Install the VSC OFF switch to the instrument cluster finish panel assembly with the 3 screws.
(b) Engage the 2 clamps to install the wire harness.
(c) Connect the connector to the VSC OFF switch.
2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
Click here .gif)
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during VSC
SEE MORE:
Camshaft Position "A" Actuator Bank 1 General Electrical Failure (P001001)
DESCRIPTION The VVT-iE system adjusts the intake valve timing using a motor. Compared to conventional hydraulic VVT systems, the valve timing can be adjusted within a wider range and can be retarded more when starting the engine. As the VVT-iE system can operate at low engine speeds and when the eng
Master Module Horizontal Axis Misalignment (C1AC1)
DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor RH deviates more than the allowable range from the horizontal axis. HINT:
If a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor s
© 2016-2026 Copyright www.lexguide.net
