Lexus ES: Canister
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 REAR FLOOR SIDE MEMBER COVER - - N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 CANISTER (CHARCOAL CANISTER ASSEMBLY) *2 LEAK
Removal
REMOVAL PROCEDURE 1. REMOVE REAR FLOOR SIDE MEMBER COVER (a) Remove the bolt and 7 clips. (b) Disengage the 3 clamps (A) and 2 clamps (B) to remove the rear floor side member cover from
Inspection
INSPECTION PROCEDURE 1. INSPECT CANISTER (CHARCOAL CANISTER ASSEMBLY) (a) Visually check the canister (charcoal canister assembly). (1) Visually check the canister (charcoal canister assembly) for
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during side turn signal light assembly removal/installation are shown below. Necessary Procedure After Parts R
Motor Control Relay Stuck ON (B2345)
DESCRIPTION This DTC will be stored if the operation of the sliding roof is suspended and a pulse input of 10 Hz or more is detected when the motor relay is off. DTC No. Detection Item DTC Detection Condition Trouble Area B2345 Motor Control Relay Stuck ON Position failure (When the
© 2016-2026 Copyright www.lexguide.net
