Lexus ES: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK
(a) When the engine switch is turned on (IG), check that the ABS warning light, brake warning light / red (malfunction), slip indicator light, VSC OFF indicator light, brake hold standby indicator light and brake hold operated indicator light come on for approximately 3 seconds.
HINT:
If the warning lights and indicator lights does not illuminate or illuminates for more than approximately 3 seconds, perform troubleshooting for the electronically controlled brake system.
Click here
READ NEXT:
DESCRIPTION The skid control ECU (brake actuator assembly) receives stop light switch assembly signals and uses them to determine whether or not the brakes are applied. When the brake pedal is depress
DESCRIPTION The skid control ECU (brake actuator assembly) receives stop light switch assembly signals and uses them to determine whether or not the brakes are applied. When the brake pedal is depress
DESCRIPTION The skid control ECU (brake actuator assembly) receives stop light switch assembly signals and uses them to determine whether or not the brakes are applied. DTCs may be stored if either of
SEE MORE:
DESCRIPTION DTC C1681 is stored if the parking assist ECU judges as a result of its self check that a synchronization problem is occurring in the image signal sent from the front television camera assembly to the parking assist ECU. DTC No. Detection Item DTC Detection Condition Trouble Are
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following systems after the cable is reconnected. System Name See Procedure Lane Control System (for H
© 2016-2026 Copyright www.lexguide.net
