Lexus ES: Calibration
CALIBRATION
NOTICE:
- Initial AWD functions such as acceleration are sometimes affected unless backup memory is cleared.
- When the yaw rate and acceleration sensor (airbag ECU assembly) is replaced, Reset Memory must be performed.
RESET MEMORY
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG).
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / Four Wheel Drive / Utility / Reset Memory.
Chassis > Four Wheel Drive > Utility| Tester Display |
|---|
| Reset Memory |
(f) Operate the Techstream to clear the data.
READ NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faul
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Dynamic Torque Control AWD System DTC No. Detection Item Link C120C Linear Solenoid Power Supply System Malfunction C1241 Low or High Power Supply
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Check the DTCs. (1) Connect the Techstream to the DLC3. (2) Turn the engine switch on (IG). (3) Turn the Techstream on. (4) Read the DTCs following the prompts on the T
SEE MORE:
Luggage Compartment Door Closer does not Operate
DESCRIPTION The luggage compartment door closer operation controls the luggage door closer assembly via the luggage closer motor assembly based on switch signals in the luggage door closer assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
Check that B2250 or B2251 is not output before pro
Components
COMPONENTS ILLUSTRATION *1 FRONT FENDER APRON SEAL RH *2 V-BANK COVER SUB-ASSEMBLY N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 CAMSHAFT TIMING GEAR BOLT *2 O-RING *3 CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Exhaust Side of Bank 2) -
© 2016-2026 Copyright www.lexguide.net
