Lexus ES manuals

Lexus ES: Dtc Check / Clear

Lexus ES (XZ10) Service Manual / Drivetrain / Gf1a (transfer / 4wd / Awd) / Dynamic Torque Control Awd System / Dtc Check / Clear

DTC CHECK / CLEAR

CHECK DTC

(a) Check the DTCs.

(1) Connect the Techstream to the DLC3.

(2) Turn the engine switch on (IG).

(3) Turn the Techstream on.

(4) Read the DTCs following the prompts on the Techstream screen. Enter the following menus: Chassis / Four Wheel Drive / Trouble Codes.

Chassis > Four Wheel Drive > Trouble Codes

(5) Check the details of the DTCs.

Click here

CLEAR DTC

(a) Clear the DTCs.

(1) Connect the Techstream to the DLC3.

(2) Turn the engine switch on (IG).

(3) Turn the Techstream on.

(4) Operate the Techstream to clear the DTCs. Enter the following menus: Chassis / Four Wheel Drive / Trouble Codes.

Chassis > Four Wheel Drive > Clear DTCs

(5) According to the display on the Techstream, select the trouble code data display with the clear button.

READ NEXT:

 Fail-safe Chart

FAIL-SAFE CHART FAIL-SAFE CHART Dynamic Torque Control AWD System DTC No. Trouble Area AWD Warning Message Fail-safe Operation Memory Fail-safe Deactivation Condition C120C Linear S

 Freeze Frame Data

FREEZE FRAME DATA FREEZE FRAME DATA (a) When a DTC is stored, the 4WD ECU assembly stores the current vehicle state as Freeze Frame Data. HINT: Freeze Frame Data at the time a DTC is stored: When t

 How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT HINT: Use the following procedure listed to troubleshoot the Dynamic Torque Control AWD System. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP

SEE MORE:

 Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front exhaust pipe assembly (TWC: Rear Catalyst), center exhaust pipe assembly and tail exhaust pipe ass

 Installation

INSTALLATION PROCEDURE 1. TEMPORARILY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (a) When reusing a propeller with center bearing shaft assembly and rear differential carrier assembly: (1) Align the matchmarks on the rear differential carrier assembly and propeller with center bearing s

© 2016-2026 Copyright www.lexguide.net