Lexus ES: Body
BODY
TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY
(a) If necessary, tighten the bolts and nuts on the chassis parts listed below.
- Front axle and suspension
- Drivetrain
- Rear axle and suspension
- Brake system
- Engine mounts
- Other chassis parts
(b) If necessary, tighten the bolts and nuts on the body parts listed below.
- Seat belt system
- Seats
- Doors and hood
- Body mounts
- Fuel tank
- Exhaust system
- Other body parts
CLEAN OR REPLACE AIR CONDITIONING FILTER
(a) Remove the air conditioning filter.
Click here .gif)
(b) Visually inspect the surface of the air conditioning filter.
(c) If the air conditioning filter is contaminated with foreign matter, clean or replace it according to the maintenance schedule.
NOTICE:
Some filters are not able to be cleaned.
ROAD TEST
(a) Check the engine and chassis for abnormal noises.
(b) Check that the vehicle does not wander or pull to one side.
(c) Check that the brakes work properly and do not drag.
(d) Bed-in the parking brake pads.
BODY INSPECTION
(a) Check the body exterior for dents, scratches and rust.
(b) Check the underbody for rust and damage.
If necessary, replace any damaged parts or repair any damaged areas.
FINAL INSPECTION
(a) Check the operation of the body parts.
(1) Hood
- Auxiliary catch operates properly.
- Hood locks securely when closed.
(2) Front and rear doors
- Door locks operate properly.
- Doors close properly.
(3) Luggage compartment door
Luggage compartment door opens and closes properly.
(4) Seats
- Seats adjust easily and lock securely in any position.
- Front seatbacks lock securely in any position.
- Fold-down rear seatbacks lock securely.
(5) Be sure to deliver a clean car. Make sure to check the following:
- Steering wheel
- Shift lever knob
- All switches and knobs
- Door handles
- Seats
READ NEXT:
Components
COMPONENTS
ILLUSTRATION
*1
FRONT WHEEL OPENING EXTENSION PAD RH
*2
FRONT WHEEL OPENING EXTENSION PAD LH
*3
NO. 1 ENGINE UNDE
Replacement
REPLACEMENT
PROCEDURE
1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
Click here
2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
Click here
3. REMOVE NO. 1 ENGINE UNDER COVER
Click here
SEE MORE:
Brake
BRAKE
INSPECT BRAKE LINE PIPES AND HOSES
HINT:
Work in a well-lighted area. Turn the front wheels fully to the right or left
before beginning the inspection.
(a) Using a mirror, check the entire circumference and length of the brake lines
and hoses for:
Damage
Wear
Deformatio
Components
COMPONENTS ILLUSTRATION *1 DRIVE SHAFT BEARING BRACKET *2 FRONT DRIVE SHAFT OIL SEAL LH *3 FRONT DRIVE SHAFT OIL SEAL RH - - N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part Do not apply lubricants to the threaded parts - -
