Lexus ES manuals

Lexus ES: ANC ECU EEPROM Data Memory Failure (B1AA044)

DESCRIPTION

This DTC is stored when a malfunction occurs in the stereo component equalizer assembly.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

B1AA044

ANC ECU EEPROM Data Memory Failure

Stereo component equalizer assembly malfunction

Stereo component equalizer assembly

PROCEDURE

1.

CLEAR DTC

(a) Clear the DTCs.

Body Electrical > Active Noise Control > Clear DTCs
NEXT

2.

CHECK FOR DTC

(a) Check for DTCs.

Body Electrical > Active Noise Control > Trouble Codes

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

REPLACE STEREO COMPONENT EQUALIZER ASSEMBLY

READ NEXT:

 UART Communication Between ANC and Audio Amplifier Missing Message (B1AA187)

DESCRIPTION This DTC is stored when an UART communication error occurs between the stereo component equalizer assembly and stereo component amplifier assembly. DTC No. Detection Item DTC Detect

 Front Left Microphone Circuit Component Internal Failure (B1AA296,B1AA31C)

DESCRIPTION These DTCs are stored when a malfunction occurs in the No. 1 active noise control microphone system. DTC No. Detection Item DTC Detection Condition Trouble Area B1AA296 Fron

 Front Right Microphone Circuit Component Internal Failure (B1AA696,B1AA71C)

DESCRIPTION These DTCs are stored when a malfunction occurs in the No. 2 active noise control microphone system. DTC No. Detection Item DTC Detection Condition Trouble Area B1AA696 Fron

SEE MORE:

 Internal Control Module Software Incompatibility Invalid / Incompatible Software Component (U030057)

DESCRIPTION The forward recognition camera receives the vehicle information from the hybrid vehicle control ECU via CAN communication. If the vehicle information stored in the forward recognition camera does not match the vehicle information sent from the hybrid vehicle control ECU, the forward reco

 Remote Service Malfunction

PROCEDURE 1. CHECK CAN COMMUNICATION SYSTEM (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Bus Check. Click here (e) Check that all ECUs and sensors that use CAN communication are connected. Result

© 2016-2025 Copyright www.lexguide.net