Lexus ES manuals

Lexus ES: Utility

Lexus ES (XZ10) Service Manual / Power Source & Network / Networking / Can Communication System (for Gasoline Model) / Utility

UTILITY

INITIALIZE THE CONNECTION INFORMATION OF A GATEWAY FUNCTION EQUIPPED ECU (BUS MONITOR ECU)

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus:

  • for Body Electrical / Central Gateway / Utility / Initialization
Body Electrical > Central Gateway > Utility

Tester Display

Initialization
  • for Body Electrical / Main Body / Utility / Initialization
Body Electrical > Main Body > Utility

Tester Display

Initialization

(e) Initialize the ECU.

READ NEXT:

 How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT PRECAUTIONS WHEN TROUBLESHOOTING NOTICE: Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with

 System Description

SYSTEM DESCRIPTION BRIEF DESCRIPTION (a) The Controller Area Network (CAN) is a serial data communication system for real time application. It is a vehicle multiplex communication system which has a h

 System Diagram

SYSTEM DIAGRAM (a) The CAN communication system is composed of 5 buses. CAN Main Bus Line Terminating Resistor CAN Branch Line * Gateway Function Equipped ECU Bus Monitor

SEE MORE:

 Components

COMPONENTS ILLUSTRATION *A for Front Side *B for Rear Side *1 ACTIVE NOISE CONTROL MICROPHONE - -

 Installation

INSTALLATION PROCEDURE 1. INSTALL BLIND SPOT MONITOR BUZZER (a) Connect the connector. (b) Engage the clamp to install the blind spot monitor buzzer. 2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade) Click here 3. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade) Click here

© 2016-2026 Copyright www.lexguide.net