Lexus ES: Ua80e Automatic Transaxle Fluid
READ NEXT:
Components
COMPONENTS
ILLUSTRATION
*A
Type A
*B
Type B
*1
FRONT FENDER APRON SEAL LH
*2
FRONT WHEEL OPENING EXTEN
Replacement
REPLACEMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration)
that must be performed after parts are removed and installed, or replaced dur
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT AIR FUEL RATIO SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 (HA1A) - 2 (+B) 20°C (68°F) 1.6 to 3.2 Ω 1 (HA1A) - 4 (A1A-) Always 10 k
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT BRAKE BOOSTER ASSEMBLY (a) Airtightness check (1) Start the engine and stop it after 1 or 2 minutes. Slowly depress the brake pedal several times. HINT: If the brake pedal can be depressed nearly to the floor the first time, but on the 2nd and 3rd time c
© 2016-2023 Copyright www.lexguide.net
