Lexus ES: Transfer Assembly
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 PROPELLER SHAFT HEAT INSULATOR *2 NO. 1 PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY *3 REAR ENGINE MOUNTING BRACKET SUB-ASSEMBLY *4 TRANSFER ASSE
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT NOTICE: Before installation of each part, thoroughly clean and dry it. Then apply grease or oil as necessary. Do not use alkaline chemicals to clean aluminum parts,
Installation
INSTALLATION PROCEDURE 1. INSTALL TRANSFER ASSEMBLY (a) Using SST and a 17 mm union nut wrench, install the transfer assembly to the automatic transaxle assembly with the 8 nuts. SST: 09961-00950 T
SEE MORE:
Drive Motor "A" Position Sensor Internal Electronic Failure (P1CAD49,P1C651F,P1CB038)
DESCRIPTION The motor generator control ECU (MG ECU) , which is built into the inverter with converter assembly, monitors its internal operation and detects malfunctions. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P1C651F Generator Control Mod
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use these procedures to troubleshoot the heated steering wheel system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT 2. INSPECT BATTERY VOLTAGE (a) Measure the battery voltage with the engine switch off.
© 2016-2026 Copyright www.lexguide.net
