Lexus ES: System Description
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Door / Hatch / Fuel Lid Opener System (for Hv Model) / System Description
SYSTEM DESCRIPTION
When the trunk and fuel switch assembly (fuel lid opener switch) is operated, the pressure in the fuel tank is decreased and a message is displayed on the multi-information display. After the pressure has decreased, the ECM turns on the FUEL OPN relay to operate the fuel lid lock with motor assembly to open the fuel lid. When the fuel lid is opened, a fuel lid courtesy switch signal is output and a message is displayed on the multi-information display.
READ NEXT:
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use the following procedure to troubleshoot the fuel lid opener system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT
Operation Check
OPERATION CHECK CHECK FUEL LID OPENER SYSTEM Push the trunk and fuel switch assembly (fuel lid opener switch) and check that messages are displayed on the multi-information display in the combination
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of
SEE MORE:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Charging System DTC No. Detection Item Warning Indicate Memory Note Link P161A87 Lost Communication with Alternator Missing Message Charge warning is not displayed DTC stored SAE Code: P161A
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear television camera assembly removal/installation are shown below. Necessary Procedure After Parts R
© 2016-2026 Copyright www.lexguide.net
