Lexus ES: System Description
SYSTEM DESCRIPTION
LIN COMMUNICATION SYSTEM DESCRIPTION
The LIN communication system is used for communication between the components in the tables below. If communication cannot be performed through LIN communication such as when there is an open or short in a communication line, the master control ECU of the relevant system will store a DTC. Refer to the table below about the communication bus lines and connected components.
HINT:
- Each component has a fail-safe function which operates in the event of a malfunction to protect the system and allow communication between other components to continue.
- In the following table, "○" indicates that the function applies, and "-" indicates that it does not.
| Component | Master Control | LIN Communication DTC Output Function |
|---|---|---|
| Main Body ECU (Multiplex Network Body ECU) | ○ | ○ |
| Power Window Regulator Motor Assembly (Driver Door) | - | - |
| Power Window Regulator Motor Assembly (Front Passenger Door) | - | - |
| Power Window Regulator Motor Assembly (Rear LH Door) | - | - |
| Power Window Regulator Motor Assembly (Rear RH Door) | - | - |
| Multiplex Network Master Switch Assembly | - | - |
| Sliding Roof ECU (Sliding Roof Drive Gear Sub-assembly)*1 | - | - |
| Sliding Roof ECU (Sliding Roof Drive Gear Assembly)*2 | - | - |
| Kick Door Control Sensor*3 | - | - |
- *1: w/ Sliding Roof System
- *2: w/ Panoramic Moon Roof System
- *3: w/ Power Trunk Lid System
| Component | Master Control | LIN Communication DTC Output Function |
|---|---|---|
| Certification ECU (Smart Key ECU Assembly) | ○ | ○ |
| Steering Lock ECU (Steering Lock Actuator or Upper Bracket Assembly) | - | - |
| ID Code Box (Immobiliser Code ECU) | - | - |
READ NEXT:
System Diagram
SYSTEM DIAGRAM DOOR BUS LINES CERTIFICATION BUS LINES
Parts Location
PARTS LOCATION ILLUSTRATION *A for Manual Tilt and Manual Telescopic Steering Column *B for Power Tilt and Power Telescopic Steering Column *C w/ Power Trunk Lid System - - *1
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cab
SEE MORE:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Wiper and Washer System DTC No. Detection Item DTC Output from Link B1245 Lost Communication with Wiper ECU LIN Main Body B1279 Lost Communication with Humidity/Rain Sensor LIN Main Body B1370 ECU Malfunction Windshield wiper m
Transmitter ID not Received (Main) (C2126)
DESCRIPTION If ID registration via the automatic ID registration function is canceled or the tire pressure warning ECU and receiver does not receive data from the tire pressure warning valve and transmitters after the tire pressure warning valve and transmitter ID registration is completed using the
