Lexus ES manuals

Lexus ES: Stereo Component Amplifier Malfunction (B15A3)

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Navigation / Multi Info Display / Navigation System (for Gasoline Model) / Stereo Component Amplifier Malfunction (B15A3)

DESCRIPTION

This DTC is stored when a malfunction occurs in the stereo component amplifier assembly.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

B15A3

Stereo Component Amplifier Malfunction

When any of the following conditions is met:

  • Internal power supply malfunction
  • DSP error
  • EEPROM error

Stereo component amplifier assembly

PROCEDURE

1.

CHECK DTC

(a) Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs

(b) Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY

READ NEXT:

 Display Malfunction (B15A6,B15B0)

DESCRIPTION These DTCs are stored when a malfunction occurs in the multi-display assembly. DTC No. Detection Item DTC Detection Condition Trouble Area B15A6 Display Malfunction When a

 Navigation Processor Malfunction (B15AD)

DESCRIPTION This DTC is stored when a malfunction occurs in the navigation ECU. DTC No. Detection Item DTC Detection Condition Trouble Area B15AD Navigation Processor Malfunction When

 GPS Antenna Connection Malfunction(short) (B15C0,B15C1)

DESCRIPTION These DTCs are stored when a malfunction occurs in the navigation antenna assembly. DTC No. Detection Item DTC Detection Condition Trouble Area B15C0 GPS Antenna Connection

SEE MORE:

 If the electronic key does not operate properly

If communication between the electronic key and vehicle is interrupted or the electronic key cannot be used because the battery is depleted, the smart access system with push-button start and wireless remote control cannot be used. In such cases, the doors and trunk can be opened and the hyb

 Reassembly

REASSEMBLY PROCEDURE 1. INSTALL SUNSHADE TRIM SUB-ASSEMBLY (a) Make sure that the No. 1 sliding roof shoe sub-assembly is positioned as shown in the illustration. HINT: Use the same procedure for the RH side and LH side. *a No. 1 Sliding Roof Shoe Sub-assembly *b Cutout

© 2016-2026 Copyright www.lexguide.net