Lexus ES: Sound of Portable Player cannot be Heard from Speakers or Sound is Low
PROCEDURE
| 1. | CHECK PORTABLE PLAYER SETTINGS |
(a) Check the portable player settings.
(1) Check that the volume is not set to "0".
(2) Check that mute is off.
(b) Check that the sound of the portable player can be heard from the speakers.
OK:
Sound of the portable player can be heard from the speakers.
| OK |  | END |
|
| 2. | CHECK AUDIO SETTINGS |
(a) Check the audio system settings.
(1) Check that the volume is not set to "0".
(b) Check that the sound of the portable player can be heard from the speakers.
OK:
Sound of the portable player can be heard from the speakers.
| OK | | END |
|
| 3. | CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL |
(a) Check that the sound of the portable player can be heard from the speakers of another "Bluetooth" audio compatible vehicle of the same model.
OK:
Sound of the portable player can be heard from the speakers.
| OK | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
.gif)
| NG | | MALFUNCTION IN PORTABLE PLAYER |
READ NEXT:
Sound Quality is Bad Only when CD is Played (Volume is Too Low)
CAUTION / NOTICE / HINT NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Pre
Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier
DESCRIPTION The radio receiver assembly sends a sound signal to the stereo component amplifier assembly via this circuit. The sound signal that has been sent is amplified by the stereo component ampli
Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
DESCRIPTION The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio receiver assembly via this circuit. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND
SEE MORE:
Airbag Signal Signal Plausibility Failure (B15C464)
DESCRIPTION If the DCM (telematics transceiver) detects an error in communication between the DCM (telematics transceiver) and the airbag ECU assembly as a result of the DCM (telematics transceiver) self check, this DTC will be set. DTC No. Detection Item DTC Detection Condition Trouble Are
Terminals Of Ecu
TERMINALS OF ECU NOTICE:
Turning the power switch on (IG) with connectors disconnected may cause DTCs to be stored. Make sure to clear the DTCs after inspection has been performed.
Do not apply excessive force to the millimeter wave radar sensor assembly connector.
CHECK MILLIMETER WAVE RAD
