Lexus ES manuals

Lexus ES: Side Camera RH Internal Circuit (C2A62)

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Panoramic View Monitor System (for Hv Model) / Side Camera RH Internal Circuit (C2A62)

DESCRIPTION

This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the side television camera assembly RH via CAN communication.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C2A62

Side Camera RH Internal Circuit

A signal indicating a malfunction in the side television camera assembly RH is detected.

Side television camera assembly RH

CAUTION / NOTICE / HINT

NOTICE:

  • When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

    Click here

PROCEDURE

1.

CHECK FOR DTC

(a) Clear the DTCs.

Chassis > Circumference Monitoring Camera Control Module > Clear DTCs

(b) Check for DTCs.

Chassis > Circumference Monitoring Camera Control Module > Trouble Codes

OK:

DTC C2A62 is not output.

OK

END
NG

REPLACE SIDE TELEVISION CAMERA ASSEMBLY RH

READ NEXT:

 Back Camera Internal Circuit (C2A63)

DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the rear television camera assembly via CAN communication. DTC No. Detection Item DTC Det

 Wheel Speed Sensor Malfunction (C164D)

DESCRIPTION This DTC is stored when the parking assist ECU receives a wheel speed sensor (front speed sensor RH or front speed sensor LH, rear speed sensor RH or rear speed sensor LH) abnormality s

 Vehicle Information Unmatched (C168D)

DESCRIPTION This DTC is stored if the parking assist ECU judges as a result of its self check that the vehicle information received via CAN communication and the vehicle information stored in the p

SEE MORE:

 Installation

INSTALLATION PROCEDURE 1. INSTALL HOLE PLUG (a) Install the 7 hole plugs to the front frame assembly. HINT: There are 2 different shapes of hole plug. 2. INSTALL FRONT SUSPENSION MEMBER BODY MOUNTING REAR CUSHION LH (a) Align a new front suspension member body mounting rear cushion LH as shown in t

 Smart access system with push-button start

The following operations can be performed simply by carrying the electronic key on your person, for example in your pocket. The driver should always carry the electronic key. Locks and unlocks the doors Opens the trunk Starts the hybrid system ■Antenna location Antennas outsi

© 2016-2026 Copyright www.lexguide.net