Lexus ES manuals

Lexus ES: Screen Flicker or Color Distortion

PROCEDURE

1.

CHECK DISPLAY SETTING

(a) Reset display settings (contrast, brightness) and check that the screen appears normal.

OK:

The display returns to normal.

OK

END (DISPLAY SETTING WAS CAUSE OF MALFUNCTION)

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

READ NEXT:

 Sound of Portable Player cannot be Heard from Speakers or Sound is Low

PROCEDURE 1. CHECK PORTABLE PLAYER SETTINGS (a) Check the portable player settings. (1) Check that the volume is not set to "0". (2) Check that mute is off. (b) Check that the sound of the po

 Sound Quality is Bad Only when CD is Played (Volume is Too Low)

CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Pre

 Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier

DESCRIPTION The radio receiver assembly sends a sound signal to the stereo component amplifier assembly via this circuit. The sound signal that has been sent is amplified by the stereo component ampli

SEE MORE:

 Drive Motor "A" Temperature Sensor Voltage Out of Range (P0A2A1C,P0A2A1F)

DTC SUMMARY MALFUNCTION DESCRIPTION These DTCs are stored when the motor temperature sensor output is abnormal. The cause of this malfunction may be one of the following: Motor temperature sensor malfunction Internal motor temperature sensor malfunction Open or short in motor temperature sensor

 Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL OUTER MIRROR CONTROL ECU ASSEMBLY (a) Install the outer mirror control ECU assembly with the 2 screws. (b) Connect the 2 connectors.

© 2016-2026 Copyright www.lexguide.net