Lexus ES manuals

Lexus ES: Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

  • Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  • Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Sliding Roof System

Symptom

Suspected Area

Link

Remote control system does not operate

Refer to the "Remote Control System does not Operate".

Key-off operation function operates even if operating conditions are not satisfied

Refer to the "Key-off Operation Function Operates even if Operating Conditions are not Satisfied".

Sliding roof does not move by operating sliding roof control switch

Refer to the "Sliding Roof does not Move by Operating Sliding Roof Control Switch".

READ NEXT:

 Terminals Of Ecu

TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) (a) Disconnect the P22 sliding roof ECU (sliding roof drive gear sub-assembly) connector. (b) Measure the resistance and

 Diagnosis System

DIAGNOSIS SYSTEM DESCRIPTION (a) Sliding roof system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3). When the system seems to be malfunctioning,

 Dtc Check / Clear

DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Sliding Roof / Trou

SEE MORE:

 Motor Generator ECU(EEPROM) Calibration / Parameter Memory Failure (P1C2E46)

DESCRIPTION The motor generator control ECU monitors its internal operation and will store this DTC if it detects a malfunction in its EEPROM. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P1C2E46 Motor Generator ECU(EEPROM) Calibration / Paramet

 Customize Parameters

CUSTOMIZE PARAMETERS CUSTOMIZE HEATED STEERING WHEEL SYSTEM (a) Customizing with the Techstream. NOTICE: When the customer requests a change in a function, first make sure that the function can be customized. Be sure to make a note of the current settings before customizing. When troubleshoot

© 2016-2026 Copyright www.lexguide.net