Lexus ES: Problem Symptoms Table
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / Cruise Control / Front Camera System (for Gasoline Model) / Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
| Symptom | Suspected Area | Link |
|---|---|---|
| "Front Camera Unavailable See Owner's Manual" is displayed | Vehicle Control History (Front Camera System) | |
| "Front Camera Unavailable" is displayed | Vehicle Control History (Front Camera System) | |
| Vehicle Control History (Pre-collision System) | |
.gif)
READ NEXT:
Terminals Of Ecu
TERMINALS OF ECU NOTICE:
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed.
D
Diagnosis System
DIAGNOSIS SYSTEM DIAGNOSIS FUNCTION (a) If a malfunction is detected in the forward recognition camera, the forward recognition camera stores a DTC without directly informing the driver via indicator
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Chassis > Front Recognition Camera
SEE MORE:
Torque Converter Clutch Actuator Stuck On (P07407E)
DESCRIPTION The ECM uses signals from the throttle position sensor, mass air flow meter, transmission revolution sensor (NT), transmission revolution sensor (NC) and crankshaft position sensor to help determine the engagement timing of the lock-up clutch. The ECM monitors the engagement of the clutc
ABS Operates Before Necessary When Braking
DESCRIPTION Troubleshooting for when ABS operates too soon due to a noisy signal from the speed sensor, a difference in output, etc. CAUTION / NOTICE / HINT NOTICE:
After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed s
© 2016-2026 Copyright www.lexguide.net
