Lexus ES manuals

Lexus ES: Precaution

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Cellular Communication / Lexus Enform System (for Hv Model) / Precaution

PRECAUTION

PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

  • After the power switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
  • When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following systems after the terminal is reconnected.

    System Name

    See Procedure

    Lane Control System

    Parking Support Brake System

    Parking Assist Monitor System

    Panoramic View Monitor System

    Pre-collision System

    Power Trunk Lid System

    Lighting System

(a) If the cable has been disconnected from the negative (-) auxiliary battery terminal before 60 seconds has elapsed, it is necessary to initialize the system. To initialize the system, perform the following procedures:

  1. Move the vehicle to an open area with good GPS reception.

    HINT:

    The GPS icon is displayed on the map screen when the reception is good.

  2. Turn the power switch on (IG), and then wait several minutes while the system acquires time and location data and activates Destination Assist and Destination.

PRECAUTION FOR REGISTRATION

(a) If replacing any of the following parts, refer to Registration.

Click here

(1) DCM (telematics transceiver)

READ NEXT:

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE NOTICE: After replacing the radio receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the XM radio ID is necessary (w/ SXM Functi

 System Description

SYSTEM DESCRIPTION DESCRIPTION LEXUS ENFORM allows the vehicle to receive information from the call center and links the information to the audio and visual system*1 or navigation system*2. LEXUS E

 System Diagram

SYSTEM DIAGRAM w/ Navigation System

SEE MORE:

 Crankshaft Position - Camshaft Position Correlation Bank 1 Sensor A (P001600)

DESCRIPTION Refer to DTC P001001. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P001600 Crankshaft Position - Camshaft Position Correlation Bank 1 Sensor A Deviation in the crankshaft position sensor signal and camshaft position senso

 Disassembly

DISASSEMBLY PROCEDURE 1. SEPARATE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP (a) Secure the drive shaft in a vise between aluminum plates. NOTICE: Do not overtighten the vise. (b) Using pliers, separate the front No. 2 axle inboard joint boot clamp as shown in the illustration. 2. SEPA

© 2016-2026 Copyright www.lexguide.net