Lexus ES manuals

Lexus ES: Precaution

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Audio / Video / Audio And Visual System (for Hv Model) / Precaution

PRECAUTION

PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

  • After the power switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
  • When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following systems after the terminal is reconnected.

    System Name

    See Procedure

    Lane Control System (for HV Model)

    Parking Support Brake System (for HV Model)

    Parking Assist Monitor System (for HV Model)

    Panoramic View Monitor System (for HV Model)

    Pre-collision System (for HV Model)

    Power Trunk Lid System (for HV Model)

    Lighting System (for HV Model)

PRECAUTION FOR AUDIO AND VISUAL SYSTEM

NOTICE:

  • When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
    • A communication malfunction DTC may be stored.
    • The radio receiver assembly may not operate normally.
  • When replacing the DCM (telematics transceiver), be sure to replace it with a new one (w/ Manual (SOS) Switch).

(a) If any of the following parts are replaced, refer to Initialization in Repair Instruction.

Click here

  • Radio receiver assembly*1
  • DCM (telematics transceiver)*2
  • *1: After replacing the radio receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, SiriusXM radio ID registration is necessary (w/ SXM Function).

    *2: w/ Manual (SOS) Switch

READ NEXT:

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Prec

 Radio Broadcast cannot be Received or Poor Reception

CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Pre

 Radio Receiver Power Source Circuit

DESCRIPTION This is the power source circuit to operate the radio receiver assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before perfor

SEE MORE:

 Disassembly

DISASSEMBLY CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during cylinder head removal/installation are shown below. Necessary Procedure After Parts Removed/Install

 EVAP System Tank Vapor Line Restricted/Blocked (P00FE00)

DTC SUMMARY DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P00FE00 EVAP System Tank Vapor Line Restricted/Blocked Leak detection pump creates negative pressure (vacuum) in EVAP system and EVAP system pressure is measured. When the fuel level in the

© 2016-2026 Copyright www.lexguide.net