Lexus ES: Precaution
PRECAUTION
HINT:
-
Any digits beyond the 0.01 mm (1/1000 in.) place for standard, minimum and maximum values should be used as a reference only.
-
When both standard and maximum or minimum values are listed for an inspection, use the standard value as a reference only and base any judgments on the maximum and minimum values.
READ NEXT:
DISASSEMBLY CAUTION / NOTICE / HINT NOTICE: This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts. Click here PROCE
INSPECTION PROCEDURE 1. INSPECT NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY (a) Turn the roller by hand to check that it turns smoothly. HINT: If the roller does not turn smoothly, replace the No. 1 valve
ComponentsCOMPONENTS ILLUSTRATION *1 CRANKSHAFT PULLEY ASSEMBLY *2 TIMING CHAIN COVER OIL SEAL *3 CRANKSHAFT PULLEY BOLT *4 V-RIBBED BELT N*m (kgf*cm, ft.*lbf): Specified t
SEE MORE:
TEST MODE PROCEDURE TEST MODE (SIGNAL CHECK MODE) PROCEDURE HINT:
When entering test mode (signal check mode), the tire pressure warning ECU and receiver sets all the test mode (signal check mode) DTCs first.
After the tire pressure warning ECU and receiver completes the signal check for each ins
MONITOR DESCRIPTION The ECM and grille shutter ECU send and receive signals via CAN communication. If a communication error occurs between the ECM and grille shutter ECU, the ECM stores this DTC. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note U028487
© 2016-2026 Copyright www.lexguide.net
