Lexus ES manuals

Lexus ES: Operation Check

OPERATION CHECK

CHECK WINDSHIELD DEICER SYSTEM

(a) Turn the engine switch on (IG).

(b) Check that the windshield deicer wire (windshield glass) becomes warm by operating the front wiper deicer switch.

(c) Confirm that windshield deicer system operation stops after approximately 15 minutes.

NOTICE:

If the battery voltage becomes low, battery load control will operate in order to ensure sufficient power is supplied to the power steering system. In this case, the windshield deicer system may not operate.

READ NEXT:

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE NOTICE: If the battery voltage becomes low, battery load control will operate in order to ensure sufficient power is supplied to the power steering system. In this case, the

 Terminals Of Ecu

TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY *A w/o Seat Heater *B w/ Seat Heater (a) Disconnect the G39 air conditioning amplifier assembly connector. (b) Measure the volta

 Diagnosis System

DIAGNOSIS SYSTEM CHECK DLC3 (a) Check the DLC3. Click here INSPECT BATTERY VOLTAGE (a) Measure the battery voltage. Standard Voltage: 11 to 14 V If the voltage is below 11 V, recharge or replace th

SEE MORE:

 Internal Control Module Software Incompatibility Invalid / Incompatible Software Component (U030057)

DESCRIPTION Forward recognition camera receives the vehicle information from the hybrid vehicle control ECU via CAN communication. DTC U030057 is stored when the vehicle information from the hybrid vehicle control ECU and that stored in the forward recognition camera do not match. DTC No. Detec

 Engine Stall History (P160300)

DESCRIPTION After starting the engine, this DTC is stored when the engine stops without the engine switch being operated. Using the Techstream, the conditions present when the DTC was stored can be confirmed by referring to the freeze frame data. Freeze frame data records engine conditions when a ma

© 2016-2026 Copyright www.lexguide.net