Lexus ES: On-vehicle Inspection
Lexus ES (XZ10) Service Manual / Steering / Steering Column / Steering System / On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT STEERING WHEEL FREE PLAY
(a) for Gasoline Model:
Start the engine and make sure that the vehicle is in a state in which the power steering can operate.
(b) for HV Model:
Turn the power switch on (READY) so that the power steering is ready to operate.
(c) Stop the vehicle and align the front wheels facing straight ahead.
(d) Gently turn the steering wheel right and left, and check for steering wheel free play.
Maximum Free Play:
30 mm (1.18 in.)
HINT:
If the free play exceeds the maximum, check the steering system.
Click here .gif)
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of
Adjustment
ADJUSTMENT PROCEDURE 1. STEERING WHEEL OFF CENTER ADJUSTMENT PROCEDURE (a) Inspect steering wheel off center. (1) Turn the steering wheel assembly to the center position. (2) Apply masking tape to
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL REAR DOOR ILLUMINATION LIGHT (REAR DOOR OUTSIDE HANDLE ASSEMBLY) Click here 2. INSTALL REAR DOOR SERVICE HOLE COVER Click here 3
Installation
INSTALLATION PROCEDURE 1. INSTALL LEAK DETECTION PUMP SUB-ASSEMBLY HINT: Only perform this procedure when replacement of the leak detection pump sub-assembly is necessary. (a) Engage the 2 claws to install a new leak detection pump sub-assembly to the charcoal canister sub-assembly. NOTICE:
© 2016-2026 Copyright www.lexguide.net
