Lexus ES: Lost Communication with Panoramic View Monitor Control Module (U023B)
DESCRIPTION
These DTCs are stored if there is a malfunction in the CAN communication system connected to the rear television camera assembly.
HINT:
If CAN communication system DTCs are stored, they may also be stored in other systems.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
| U023B | Lost Communication with Panoramic View Monitor Control Module | Lost Communication with Television Camera Controller | CAN communication system |
PROCEDURE
(a) Clear the DTCs.
Chassis > Parking Assist Camera > Clear DTCs
(b) Recheck for DTCs and check that no DTCs are output.
Chassis > Parking Assist Camera > Trouble Codes
HINT:
-
If CAN communication system DTCs are stored, they may also be stored in other systems.
-
If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.
-
If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform troubleshooting again, even if the DTC was not output when rechecking for DTCs.
Click here
| Result | Proceed to |
| DTCs are output | A |
| No DTCs are output | B |
| A | | GO TO CAN COMMUNICATION SYSTEM |
| B | | USE SIMULATION METHOD TO CHECK |
READ NEXT:
DESCRIPTION These DTCs are stored if there is a malfunction in the CAN communication system connected to the parking assist ECU. HINT: If CAN communication system DTCs are stored, they may also be sto
DESCRIPTION These DTCs are stored when communication between the parking assist ECU and front television camera assembly, side television camera assembly LH, side television camera RH is not possible.
DESCRIPTION If DTC U1000 is stored frequently, duplicate the problem symptoms and perform troubleshooting again even if the DTC is not output when rechecking for DTCs. DTC No. Detection Item DT
SEE MORE:
DESCRIPTION When the washer fluid level is lower than a certain level, a warning message is displayed on the combination meter assembly. WIRING DIAGRAM PROCEDURE 1. READ VALUE USING TECHSTREAM (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstre
On-vehicle InspectionON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: To prevent injury due to contact with an operating V-ribbed belt or cooling fan, keep your hands and clothing away from the V-ribbed belt and cooling fans when working in the engine compartment with the engine running or th
© 2016-2026 Copyright www.lexguide.net
