Lexus ES: Installation

INSTALLATION

PROCEDURE

1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

(a) Pass the hood lock control cable assembly into the engine compartment.

(b) Engage the grommet.

(c) Engage each clamp.

(d) Engage the clamp to install the hood lock control cable assembly.

2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

(a) Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.

3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Click here

4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here

5. INSTALL INSTRUMENT SIDE PANEL LH

Click here

6. INSTALL FRONT DOOR OPENING TRIM COVER LH

Click here

7. INSTALL COWL SIDE TRIM BOARD LH

Click here

8. INSTALL FRONT DOOR SCUFF PLATE LH

Click here

9. INSTALL HOOD LOCK ASSEMBLY

(a) Apply MP grease to the sliding areas of the hood lock assembly.

(b) Connect the hood lock control cable assembly to the hood lock assembly.

(c) Install the hood lock assembly with the 2 bolts and hood lock bolt.

Torque:

7.5 N·m {76 kgf·cm, 66 in·lbf}

HINT:

The hood lock nut cap is a non-reusable part. Be sure to install it after inspecting and adjusting the hood sub-assembly.

(d) except TMMK Made Gasoline Model:

(1) Connect the connector.

(e) for TMMK Made Gasoline Model:

(1) Connect the connector.

(2) Engage the clamp.

10. ADJUST HOOD SUB-ASSEMBLY

Click here

11. INSTALL VEHICLE APPROACHING SPEAKER ASSEMBLY (for HV Model)

Click here

12. INSTALL COOL AIR INTAKE DUCT SEAL

Click here

13. INSTALL FRONT FENDER LINER RETAINER

Click here

14. INSTALL REAR FENDER SPLASH SHIELD SUB-ASSEMBLY LH

HINT:

Use the same procedure as for the RH side.

Click here

15. INSTALL PIN HOLD CLIP

HINT:

Use the same procedure as for the RH side.

Click here

16. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

HINT:

Use the same procedure as for the RH side.

Click here

17. INSTALL FRONT WHEEL LH

Click here

READ NEXT: