Lexus ES: Installation
INSTALLATION
PROCEDURE
1. INSTALL SUSPENSION TOWER DAMPER
(a) Install the suspension tower damper to the front bumper extension sub-assembly LH and front bumper extension sub-assembly RH with the 4 bolts.
Torque:
27.5 N·m {280 kgf·cm, 20 ft·lbf}
NOTICE:
Do not extend or compress the damper.
2. INSTALL NO. 1 ENGINE UNDER COVER
for A25A-FKS: Click here
for A25A-FXS: Click here
for 2GR-FKS: Click here
3. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
for A25A-FKS: Click here
for A25A-FXS: Click here
for 2GR-FKS: Click here
4. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
for A25A-FKS: Click here
for A25A-FXS: Click here
for 2GR-FKS: Click here
READ NEXT:
DISPOSAL PROCEDURE 1. DISPOSE OF SUSPENSION TOWER DAMPER (a) Using a hacksaw, cut the cylinder between (A) and (B) shown in the illustration to discharge the gas inside. *a 10 mm CAUTION:
SEE MORE:
REMOVAL CAUTION / NOTICE / HINT NOTICE: This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts. Click here PROCEDURE 1. REMOVE FRONT FENDER APRON SEAL RH Click here 2. REMOVE OIL PRESSURE CONTROL VALVE ASSEMBLY
TEST MODE PROCEDURE TEST MODE (SIGNAL CHECK MODE) PROCEDURE HINT:
When entering test mode (signal check mode), the tire pressure warning ECU and receiver sets all the test mode (signal check mode) DTCs first.
After the tire pressure warning ECU and receiver completes the signal check for each ins
© 2016-2026 Copyright www.lexguide.net
