Lexus ES: Installation
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / A25a-fxs (lubrication) / Oil Pump / Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click here .gif)
PROCEDURE
1. INSTALL ENGINE BALANCER ASSEMBLY
Click here
2. INSTALL STIFFENING CRANKCASE ASSEMBLY
Click here
3. INSTALL OIL PUMP ASSEMBLY
(a) Install the oil pump assembly to the stiffening crankcase assembly with the 3 bolts.
Torque:
24 N·m {245 kgf·cm, 18 ft·lbf}
4. INSTALL OIL PUMP BRACKET
Click here
5. INSTALL ENGINE OIL LEVEL SENSOR
Click here
6. INSTALL OIL STRAINER SUB-ASSEMBLY
Click here
7. INSTALL NO. 2 OIL PAN SUB-ASSEMBLY
Click here
8. INSTALL TIMING CHAIN COVER ASSEMBLY
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 COWL SIDE TRIM BOARD LH *2 FRONT DOOR OPENING TRIM COVER LH *3 FRONT DOOR SCUFF PLATE LH *4 INSTRUMENT PANEL FINISH PANEL END LH *5 INSTRUMENT SIDE
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT VACUUM SWITCHING VALVE (for Active Control Engine Mount System) (a) Measure the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 - 2 20°C (68°
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE Hybrid Control System Symptom Suspected Area Link Cannot enter EV drive mode CAN communication system Pattern Select Switch EV Mode Circuit EV mode switch Combination meter assembly EV mode indicator light does not illuminate
© 2016-2026 Copyright www.lexguide.net
