Lexus ES: Installation
INSTALLATION
PROCEDURE
1. INSTALL VACUUM SWITCHING VALVE (for Active Control Engine Mount System)
(a) Install the vacuum switching valve (for active control engine mount system) to the front engine mounting insulator with the nut.
Torque:
6.0 N·m {61 kgf·cm, 53 in·lbf}
(b) Connect the 3 vacuum hoses to the vacuum switching valve (for active control engine mount system).
(c) Engage the wire harness clamp and connect the vacuum switching valve (for active control engine mount system) connector.
(d) Install the wire harness clamp bracket to the transmission case side cover with the bolt.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
(e) Engage the 2 wire harness clamps and install the engine wire with the bolt.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
2. INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
Click here .gif)
3. INSTALL INLET AIR CLEANER ASSEMBLY
Click here
4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
Click here
5. INSTALL COOL AIR INTAKE DUCT SEAL
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 IGNITION COIL ASSEMBLY *2 ENGINE WIRE *3 CAM TIMING OIL CONTROL SOLENOID ASSEMBLY *4 CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY *5 CYLINDER HEAD CO
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 5 (M-) - 6 (M+) 20°C (68°F) 0.3 to 100 Ω If the result is not as sp
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear No. 1 differential mount cushion removal/installation are shown below. Necessary Procedures After
