Lexus ES: Inspection
INSPECTION
PROCEDURE
1. INSPECT SUSPENSION TOWER DAMPER
(a) Visually check the suspension tower damper and, if the rod is bent, a leak is found or the damper cannot be installed without extending or compressing it, replace it with a new one.
NOTICE:
Do not extend or compress the damper.
READ NEXT:
Installation
INSTALLATION PROCEDURE 1. INSTALL SUSPENSION TOWER DAMPER (a) Install the suspension tower damper to the front bumper extension sub-assembly LH and front bumper extension sub-assembly RH with the 4 bo
Installation
INSTALLATION PROCEDURE 1. INSTALL SUSPENSION TOWER DAMPER (a) Install the suspension tower damper to the front bumper extension sub-assembly LH and front bumper extension sub-assembly RH with the 4 bo
Disposal
DISPOSAL PROCEDURE 1. DISPOSE OF SUSPENSION TOWER DAMPER (a) Using a hacksaw, cut the cylinder between (A) and (B) shown in the illustration to discharge the gas inside. *a 10 mm CAUTION:
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here 2. REMOVE ACCELERATOR PEDAL(W/SENSOR) ROD ASSEMBLY NOTICE:
Avoid physical shock to the accelerator pedal sensor assembly.
Do not disassemble the accelerator pedal sensor assembly.
The accelerator pedal s
Inspection
INSPECTION PROCEDURE 1. INSPECT SIDE TURN SIGNAL LIGHT ASSEMBLY LH *a Component without harness connected (Side Turn Signal Light Assembly LH) (a) Apply auxiliary battery voltage to the side turn signal light assembly LH and check that the light illuminates. OK: Measurement Condition
© 2016-2026 Copyright www.lexguide.net
