Lexus ES manuals

Lexus ES: Installation

Lexus ES (XZ10) Service Manual / Suspension / Front Suspension / Performance Damper / Installation

INSTALLATION

PROCEDURE

1. INSTALL SUSPENSION TOWER DAMPER

(a) Install the suspension tower damper to the front bumper extension sub-assembly LH and front bumper extension sub-assembly RH with the 4 bolts.

Torque:

27.5 N·m {280 kgf·cm, 20 ft·lbf}

NOTICE:

Do not extend or compress the damper.

2. INSTALL NO. 1 ENGINE UNDER COVER

for A25A-FXS: Click here

for 2GR-FKS: Click here

3. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

for A25A-FXS: Click here

for 2GR-FKS: Click here

4. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

for A25A-FXS: Click here

for 2GR-FKS: Click here

READ NEXT:

 Installation

INSTALLATION PROCEDURE 1. INSTALL SUSPENSION TOWER DAMPER (a) Install the suspension tower damper to the front bumper extension sub-assembly LH and front bumper extension sub-assembly RH with the 4 bo

 Disposal

DISPOSAL PROCEDURE 1. DISPOSE OF SUSPENSION TOWER DAMPER (a) Using a hacksaw, cut the cylinder between (A) and (B) shown in the illustration to discharge the gas inside. *a 10 mm CAUTION:

 Rear Suspension

SEE MORE:

 Components

COMPONENTS ILLUSTRATION *1 LOWER STEERING COLUMN COVER SUB-ASSEMBLY *2 UPPER STEERING COLUMN COVER *3 WINDSHIELD WIPER SWITCH ASSEMBLY - -

 Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP (a) Align the alignment mark on the front door opening trim weatherstrip with the flange on the

© 2016-2026 Copyright www.lexguide.net