Lexus ES: Initialization
INITIALIZATION
INITIALIZE PANORAMIC VIEW MONITOR SYSTEM
(a) When "!" is displayed on the multi-display assembly, correct the steering angle neutral point using the following method.
(1) Fully turn the steering wheel to the left and right on level ground.
NOTICE:
Memorizing the steering angle neutral point must be carried out with the engine running. Apply the parking brake, depress the brake pedal, check that the shift lever is in P, and ensure that the vehicle is not moving.
HINT:
If the steering angle neutral point cannot be memorized by fully turning the steering wheel to the left and right, perform Steering Angle Setting in Calibration.
Click here .gif)
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *1 FRONT TELEVISION CAMERA ASSEMBLY *2 BRAKE ACTUATOR ASSEMBLY - SKID CONTROL ECU *3 SIDE TELEVISION CAMERA ASSEMBLY RH *4 SIDE TELEVISION CAMERA ASSEMB
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cab
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE:
The following inspection procedure of the panoramic view monitor system is described on the assumption that the audio and visual system*1 or navigation system*2 is no
SEE MORE:
Vehicle Speed Sensor (C1A45)
DESCRIPTION The blind spot monitor sensor receives vehicle speed signals from the skid control ECU via CAN communication. Blind Spot Monitor Master DTC No. Detection Item DTC Detection Condition Trouble Area C1A45 Vehicle Speed Sensor A fail flag is transmitted from the skid control
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspect
© 2016-2026 Copyright www.lexguide.net
