Lexus ES manuals

Lexus ES: Initialization

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Parking Assist Monitor System (for Gasoline Model) / Initialization

INITIALIZATION

INITIALIZE PARKING ASSIST MONITOR SYSTEM

(a) When "!" mark is displayed on the image of the area behind the vehicle, perform the following procedure to correct the steering angle neutral point.

(1) Fully turn the steering wheel to the right and left on flat ground.

NOTICE:

Memorizing the steering angle neutral point must be carried out with the engine started. Apply the parking brake, depress the brake pedal, check that the shift lever is in P, and ensure that the vehicle is not moving.

HINT:

If "!" mark is displayed on the image of the area behind the vehicle with the steering wheel fully turned to the right or left, perform "Steering Angle Setting in Calibration".

Click here

READ NEXT:

 Parts Location

PARTS LOCATION ILLUSTRATION *1 ECM *2 REAR TELEVISION CAMERA ASSEMBLY *3 BLIND SPOT MONITOR SENSOR RH (w/ Blind Spot Monitor System) *4 BLIND SPOT MONITOR SENSOR LH (w/ Blind Spot

 Precaution

PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cab

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE NOTICE: The following inspection procedures for the parking assist monitor system are based on the assumption that the audio and visual system*1 or navigation system*2 is nor

SEE MORE:

 Inspection

INSPECTION CAUTION / NOTICE / HINT NOTICE: Make sure the contact surface of the cam timing control motor with EDU assembly (the surface that contacts the No. 2 timing gear cover assembly) is free of foreign matter. If the cam timing control motor with EDU assembly has been struck or dropped, re

 Vehicle Speed Sensor "A" No Signal (P050031)

DESCRIPTION The speed sensor detects the wheel speed and sends the appropriate signals to the skid control ECU. The skid control ECU converts these wheel speed signals into a pulse signal and outputs it to the ECM via the combination meter. The ECM determines the vehicle speed based on the frequency

© 2016-2026 Copyright www.lexguide.net