Lexus ES: Hybrid Vehicle Control Ecu
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / Hybrid / Battery Control / Hybrid Vehicle Control Ecu
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 HYBRID VEHICLE CONTROL ECU *2 NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY N*m (kgf*cm, ft.*lbf): Specified torque - -
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during hyb
SEE MORE:
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE REAR LIGHT GASKET (a) Remove the rear light gasket. NOTICE:
Be sure to remove all traces of the old rear light gasket from the
Open Circuit in IG1/IG2 Power Source Circuit (C1242)
DESCRIPTION Refer to DTC C1241. Click here DTC No. Detection Item INF Code DTC Detection Condition Trouble Area MIL Note C1242 Open Circuit in IG1/IG2 Power Source Circuit 111 112
INF Code: 111
When the IG1 terminal voltage is less than 3.5 V, the IG2 terminal volta
© 2016-2026 Copyright www.lexguide.net
