Lexus ES manuals

Lexus ES: Front Left Sensor Malfunction (C1AE1)

DESCRIPTION

The front corner ultrasonic sensor LH is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front corner ultrasonic sensor LH. If the front corner ultrasonic sensor LH has an open circuit or other malfunction, it will not function normally.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1AE1

Front Left Sensor Malfunction

A malfunction of the front corner ultrasonic sensor LH.

  • Front corner ultrasonic sensor LH
  • Clearance warning ECU assembly

CAUTION / NOTICE / HINT

NOTICE:

If DTCs are output after repairs, turn the engine switch on (IG) and the parking support alert system on. Then clear the DTCs.

Click here

PROCEDURE

1.

CHECK DTC OUTPUT

(a) Check for DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes

Result

Proceed to

Only DTC C1AE1 is output

A

DTC C1AE1 and C1AEC are output

B

No DTCs are output

C

B

GO TO DTC (C1AEC)

C

USE SIMULATION METHOD TO CHECK

A

2.

REPLACE FRONT CORNER ULTRASONIC SENSOR LH

(a) Replace the front corner ultrasonic sensor LH with new or a known good one.

Click here

HINT:

All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.

NEXT

3.

CHECK DTC OUTPUT

(a) Clear the DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs

(b) Check for DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes

Result

Proceed to

DTC C1AE1 is output

A

No DTCs are output

B

A

REPLACE CLEARANCE WARNING ECU ASSEMBLY

B

END (FRONT LEFT CONRNER SENSOR WAS DEFECTIVE)

READ NEXT:

 Front Left Center Sensor (C1AE2)

DESCRIPTION The front center ultrasonic sensor LH is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front center ultrasonic sens

 Front Right Center Sensor (C1AE3)

DESCRIPTION The front center ultrasonic sensor RH is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front center ultrasonic sens

 Front Right Sensor Malfunction (C1AE4)

DESCRIPTION The front corner ultrasonic sensor RH is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front corner ultrasonic sens

SEE MORE:

 On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT MASS AIR FLOW METER SUB-ASSEMBLY HINT: Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly. Click here (a) Read the value of Data List item "Mass Air Flow Sensor" using the Techstream. NOTICE: Perform the inspection of

 Precaution

PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected: System See Procedure Lane Control System Pre-collision System

© 2016-2025 Copyright www.lexguide.net