Lexus ES manuals

Lexus ES: Front Left Center Sensor (C1AE2)

DESCRIPTION

The front center ultrasonic sensor LH is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front center ultrasonic sensor LH. If the front center ultrasonic sensor LH has an open circuit or other malfunction, it will not function normally.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1AE2

Front Left Center Sensor

A malfunction of the front center ultrasonic sensor LH.

  • Front center ultrasonic sensor LH
  • Clearance warning ECU assembly

CAUTION / NOTICE / HINT

NOTICE:

If DTCs are output after repairs, turn the engine switch on (IG) and the parking support alert system on. Then clear the DTCs.

Click here

PROCEDURE

1.

CHECK DTC OUTPUT

(a) Check for DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes

Result

Proceed to

Only DTC C1AE2 is output

A

DTC C1AE2 and C1AEC are output

B

No DTCs are output

C

B

GO TO DTC (C1AEC)

C

USE SIMULATION METHOD TO CHECK

A

2.

REPLACE FRONT CENTER ULTRASONIC SENSOR LH

(a) Replace the front center ultrasonic sensor LH with new or a known good one.

Click here

HINT:

All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.

NEXT

3.

CHECK DTC OUTPUT

(a) Clear the DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs

(b) Check for DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes

Result

Proceed to

DTC C1AE2 is output

A

No DTCs are output

B

A

REPLACE CLEARANCE WARNING ECU ASSEMBLY

B

END (FRONT LEFT CENTER SENSOR WAS DEFECTIVE)

READ NEXT:

 Front Right Center Sensor (C1AE3)

DESCRIPTION The front center ultrasonic sensor RH is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front center ultrasonic sens

 Front Right Sensor Malfunction (C1AE4)

DESCRIPTION The front corner ultrasonic sensor RH is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front corner ultrasonic sens

 Rear Left Sensor Malfunction (C1AE6)

DESCRIPTION The rear corner ultrasonic sensor LH is installed to the rear bumper. The clearance warning ECU assembly detects obstacles based on signals received from the rear corner ultrasonic sensor

SEE MORE:

 Pressure Control Solenoid "B" Circuit Short to Ground or Open (P077514)

DESCRIPTION Refer to DTC P077512. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P077514 Pressure Control Solenoid "B" Circuit Short to Ground or Open While the vehicle is being driven so that gear changes occur, a short to ground or o

 Terminals Of Ecu

TERMINALS OF ECU CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (a) Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly. Click here (b) Measure the resistance according to the value(s) in the table

© 2016-2026 Copyright www.lexguide.net