Lexus ES: Freeze Frame Data
FREEZE FRAME DATA
CHECK FREEZE FRAME DATA
HINT:
Whenever an active noise control system DTC is stored, the stereo component equalizer assembly stores the current vehicle state as freeze frame data.
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Active Noise Control / Trouble Codes.
Body Electrical > Active Noise Control > Trouble Codes(e) According to the Techstream display, select a DTC that stored freeze frame data.
NOTICE:
Read the freeze frame data recorded when the DTC was stored.
LIST OF FREEZE FRAME DATA
Body Electrical > Active Noise Control| Tester Display | Measurement Item | Range | Reference Value | Diagnostic Note |
|---|---|---|---|---|
| Total Distance Traveled | Displays the current total driving distance | 0 to 16777215 | Equivalent to the actual total driving distance | Refer to the Total Distance Traveled - Unit for the units |
| Total Distance Traveled - Unit | Displays the current total driving distance units | km or mile | Units according destination | - |
READ NEXT:
How To Proceed With Troubleshooting
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT 2. CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
NEXT 3. INSPECT BATTERY VOLTAGE (a) Measure th
Input / Output Signal Circuit
DESCRIPTION The stereo component equalizer assembly uses this circuit to send and receive signals to and from the stereo component amplifier assembly. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS
Crankshaft Position Sensor "A" No Signal (P033531)
DESCRIPTION This DTC is output when a malfunction has occurred in the engine pulse signal system from the ECM. DTC No. Detection Item DTC Detection Condition Trouble Area P033531 Cranks
SEE MORE:
Stroke Sensor / Reaction Force Pressure Sensor Output Inconsistent (C14B6)
DESCRIPTION DTC No. Detection Item INF Code DTC Detection Condition Trouble Area MIL Note C14B6 Stroke Sensor / Reaction Force Pressure Sensor Output Inconsistent 209 The difference between brake pedal stroke sensor assembly output value and reaction force pressure sensor ou
Registration
REGISTRATION CAUTION / NOTICE / HINT NOTICE:
When the automatic transaxle assembly is replaced, the transaxle compensation code must be registered to the ECM (proceed to Procedure 1).
After the automatic transaxle assembly is installed, the Quick Response (QR) code label will be positioned where
